chevron_left Back

Doming

how-to image

1.

Open or create a design in Silhouette Studio and print with registration marks turned on. Allow the ink to dry before proceeding.

how-to image

2.

APPLY A LAMINATE SHEET OVER THE PRINTED PAGE WHEN USING WHITE STICKER PAPER. Use a scraper tool to carefully smooth the laminate sheet as it is applied to prevent bubbles or creases.

how-to image

3.

Proceed to cut your project using the appropriate cut settings. (Keep in mind that you need to increase your blade depth by one if you applied a laminate sheet to your page.)

how-to image

4.

Weed away the excess material from around your designs, leaving just your cutout stickers on the sticker backing.

how-to image

5.

Set your sticker sheet on a flat surface

how-to image

6.

Fill the A and B syringe chambers with equal amounts of the corresponding A and B epoxy resin solutions.

how-to image

7.

Attach the syringe tip and prime your syringe by squirting out a small amount of epoxy resin (about 1 inch in diameter) onto a scrap piece of paper. This ensures that your syringe will apply an equal mixture of the A and B solutions.

how-to image

8.

Slowly apply the epoxy resin onto the surface of your cutout design, starting from the outer edge and moving toward the inside of the design. Be careful not to over-apply the resin as the resin may overflow off the edge of your cutout design. Use the provided toothpicks to spread the resin for more complicated designs and also to remove excess air bubbles.

how-to image

9.

Allow the resin to set for 12 hours to fully cure and harden.