chevron_left Back

Stamp Material

how-to image

1.

Open design in Silhouette Studio®. Choose your page size and cutting mat to the Stamp defaults.

how-to image

2.

Remove the liner from the perforated cutting mat.

how-to image

3.

Remove the liner from the stamp material. Place the stamp material onto the mat and gently pat it into place until all air bubbles are pressed out. Do not stretch or spread the stamp material. Load the mat into your Silhouette.

how-to image

4.

Select “Stamp Material” from the Material drop-down menu in the Send panel. Adjust the blade to the recommended settings. Click “Send.”

how-to image

5.

After the Silhouette is done cutting, unload the mat.

how-to image

6.

Gently peel out the stamp. Don’t worry if the blade did not cut all the way through. The material will break away cleanly.

how-to image

7.

Arrange the stamp onto the Silhouette acrylic block that fits it most closely. Use the block’s grid for spacing and alignment.

how-to image

8.

Your stamp is ready to use. Press the stamp into the ink pad. (It’s normal to get ink on your acrylic block.)

how-to image

9.

When stamping, be sure to press straight down on a flat surface. When you’re done, wipe away excess ink with a tissue or paper towel. Rinse and dry stamps and blocks before storage.